Ecoxgear IRMS300: MicroSystem Manuel d'utilisateur télécharger pdf (Page 7)

QUICKSTART GUIDE - 1

time set up

What you need before you can use your Internet Radio:

 A broadband internet connection is required.

 A wireless (Wi-Fi) modem or router connected to your broadband (cable or DSL) internet.

NOTE: IF your wireless (Wi-Fi) network is password (WEP or WPA) protected, please obtain your

password before proceeding to Step 1. All passwords are UPPER and lower case sensitive.

Step 1: Plug the round jack from the power cord into the back of the radio and the other end into a wall

outlet. The display should turn on within approximately 4 seconds and flash a series of messages.

The messages that are briefly displayed will be „Grace Digital Radio‟, „Starting…‟ then „Scanning‟.

NOTE: If your radio does not automatically start scanning when plugged into power the 1

time, please

press the power button to turn your radio on and to view the main Internet radio menu. Scroll the large

dial to the left or right until the word „settings‟ is in brackets {}. Press the large dial inwards to select

„settings‟. On the top of the next screen please select „Network Configurations‟ by pressing the large dial

inwards. (To go back to previous menus at any time press the „back‟ button on the radio). On the top of

the next screen please select „Scan for Networks‟ by pressing the large dial inwards.

Step 2: The radio is now scanning for available Wi-Fi (wireless) network(s) in your area. After the

scanning process is complete, the radio will display the names (also referred to as SSID‟s) of one or

more wireless networks that are within range. Scroll the large „Select/Menu‟ dial to the left or right until

the name of your network (SSID) is highlighted by placing the name of the router between the brackets

{}, for example {your wireless network}. Once your router is highlighted, push the large Select dial

inwards to select your network.

NOTE: If your radio does not display the name of your wireless network (SSID) please make sure that

your router is transmitting in 802.11b/g mode. Additionally, please make sure you are within range of

your wireless network.

Step 3: The display will now prompt you to enter in your network‟s key. This „Key‟ is the same key

(password) you use to connect a wireless device (laptop, mobile phones, game console etc) to your Wi-

Fi (wireless) network. This key or password is also sometimes called a „WEP‟ or „WPA‟ password or

„code‟. If you do not know your password, please contact the person or company that set up your

network to obtain your password.

NOTE: All passwords are upper and lower case sensitive. Thus letters must be entered correctly using

upper or lower case as was used to set the password originally. Numbers are not case sensitive.

To enter in your password, scroll the large „Select‟ dial to the right or left until the 1

letter or number in

your password is located in the center of the radio‟s display. Press the large dial inward to select the 1

letter. Continue this process until the final letter or number is selected.

NOTE: If you make a mistake at anytime, press the „back‟ button to erase the letter(s) or number(s) and

select then select the correct entry. After the final letter or number in your password is selected rotate

the large dial until the word „END‟ is in the center of your display. The word „END‟ is located in front of

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Pas de commentaire

Ecoxgear IRMS300: MicroSystem Manuel d'utilisateur Page 7