Ecoxgear IRMS300: MicroSystem Manuel d'utilisateur télécharger pdf (Page 28)

Settings Menu

Choosing desired option from the Configure menu

1. Press the „Select‟ button.

(Note: if you make a mistake at any point, press the „Back‟ button to go back to the previous screen.)

2. Turn the knob until „Settings‟ is displayed

3. Press the „Select‟ button.

4. Turn the knob until the display shows the option you want.

5. Press the „Select‟ button to choose the option shown on the display. The options are explained

below.

Enables you to scan again for connection to another wireless network, or to manually configure the

network parameters. Use this if you take the Internet radio to another building where you want to use it,

or if you change your wireless router.

Use this option to download new firmware for the radio from the Grace Digital Audio portal on the

Internet. If there is new firmware available, then the radio will prompt you if you want to download it or

not. Note, at this stage, you can press the radio‟s „Back‟ button to cancel the radio beginning a firmware

upgrade. A Firmware upgrade may take several minutes, so do not switch off the power to the radio until

the operation is complete otherwise the radio may become permanently damaged.

Allows you to change the display language.

Puts all the settings back to their defaults as they were when the unit left the factory. If you perform a

factory reset on your radio you will lose all your presets and your wireless network connection.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Pas de commentaire

Ecoxgear IRMS300: MicroSystem Manuel d'utilisateur Page 28